Welcome to Kamsons

Download : Brochures | Kamsons Snapshot | Company Profile

Acrylic Polymer
Call Us On

+91 22 42029999

  1. Home
  2. Products

Single component Aqueous Polyurethane Paint (PU Paint)

PU WALLGAURD (Hygiene Wall Coating)

Single component Aqueous Polyurethane Paint (PU Paint)

PU WALLGAURD is based on Aliphatic resins and exhibits enhanced resistance to U.V. without cracking, peeling or turning yellow. It is further cross linked and has good resistance to alkalies and mild acids and solvents. PU WALLGAURD has an extremely low water vapour absorption unlike acrylics and it does not turn soft even under prolonged immersion in water and at the same time has excellent breath ability due to reverse osmosis allowing water trapped in the substrate to evaporate. It is single pack, very economical, having excellent water resistance, weathering resistance, extra ordinary adhesiveness, fast drying and very good breathing properties.

Typical Properties
Base appearance Single component Aliphatic Aqueous Polyurethane resin Based paint
Colour White or pigmented as per requirement
Consistency of pigmented Paste like thixotropic.
Solid Content 50% ± 1
Cured film Flexible, elastic, tough.
Touch dry Approx. 1 ½ hour
Hardening time Approx. 48 hours
Flash point Non inflammable.
Storage Not below 5 deg. C., protect from high temperature
Shelf Life 18 months from the date of manufacturing
Chemical resistance Good
Insulation properties Good
Roof proofing Excellent
Solar reflection Excellent
Water impermeability Excellent
Advantages

Life and durability of the structure is increased.

  • Non-yellowing and Anti-fungal.
  • Easy application, no machinery required.
  • Provides seamless and joint free seal throughout the surface, which is impervious to water.
  • Lower labour cost due to easy, simple and quick application.
  • Excellent bonding to most building materials.
  • As the system is a water based system it is non-hazardous as compared to solvent based systems and can be used for laying of clean rooms.
  • As the molecule size is 0.010 microns it has excellent penetration and sealing capacity and can be used on the base plaster against efflorescence before putty and paint.
Surface Preparation

Surface should be free of dust and loose particles. It should be thoroughly abraded by a wire brush and loose particles should be removed by washing or air blown. The surface should be free of any oil or grease. It can be applied on damp and moist surface also.

Special Instruction

Stir the contents of the drum containing the material thoroughly to disperse settled material if any.

Coverage

Coverage depends upon the nature of the surface to be applied. But an average, smooth surface will give approx. 80 to100 sq.ft per coat.

Safety

Non hazardous. If ingested, seek medical help immediately.

Packing

PU WALLGAURD is available in 20 kgs. & 200 kgs. plastic drums.

Acrylic Polymer
request.quote
<< BACK